How to Use WPS Find Content on Windows

Use Find Content with 2 how-to topics, covering action selection and parameter setup; open a topic from the index and follow the steps to complete the configuration.

How-to Index

How-to Guide

1. Select the action

Entry path: Select an Action panel → Multidimensional Table → Find Content

1. Open the automation editor and go to Step 2, the Select an Action panel.
2. Under the Multidimensional Table category, click Find Content.
3. After selecting it, check whether the Configure Parameters area appears on the right.

Success Criteria

• Interface result: the right panel shows the parameter settings for this action.
• Next step available: you can continue to choose a table, search scope, and search fields.

Tips While Using

• Common mistake: if you do not open the Multidimensional Table category first, Find Content may be harder to locate.
• Environment note: you must enter the automation editor before adding this action.

2. Configure parameters

Entry path: Configure Parameters panel

1. In the Select the table containing the records dropdown, choose the target table.
2. In the Set search scope dropdown, choose a scope such as all records, records that meet conditions, or the record triggered in Step 1.
3. In the Select content to find dropdown, choose the fields to search, and select at least one field.
4. In the When no content is found area, choose how the flow should respond: continue, or stop the current branch and continue other branches.
5. Click Save and Enable to finish the setup.

Success Criteria

• Interface result: all required parameters are selected and the save action is available.
• Next step available: the flow can be enabled and the lookup result can be used in later steps.

Tips While Using

• Common mistake: if no search field is selected, the setup cannot be saved.
• Environment note: you need access permission for the target table.
• Flow logic note: choosing Stop only stops the current branch and does not affect other branches.